Kawasaki Teryx Dash Frame Installation Manual

download
The BRP Dash Frame mounts in place of the factory cup holder/storage pocket. Remove the screws holding the cup holder or storage pocket from the back of the dash and remove it. Hold the Dash Frame up on your dash. The top of the frame includes a channel that your dash slips into to provide support. Press the frame firmly up and against the dash. Be sure the frame is centered and straight. Using the frame as your template drill out the two top holes using a 13/64″ drill. Each hole is located at the top corner of the frame. Alternatively, you can mark the location of the holes, then drill them out with the frame removed. Using the smaller button head bolts supplied with this kit, along with the nylock nut and rubber backed washer, mount each of the two top corners of the frame. Use caution when tightening however. The angle of the dash frame is different than the angle of your plastic dash. The two bolts are only needed to snug the frame against your dash. You should only snug the bolt up, but don’t tighten it down. Looking from the back of the dash, you’ll see that the rubber washer does not lay flat against the plastic of the dash. This is correct. Again, these bolts are only to snug the frame against your dash and should not be tightened down. Doing so could damage your dash. The supplied nuts are nylock and will not back off even though the bolt is not tightened.